Compatible with Sony a6000, a6300 and a?6500
cameras.
* When the headset accommodates the a6500, the camera's C1/C2 buttons cannot be used
.
* MDX-?6300 headsets with the following serial numbers (last four digits) are compatible with all the above cameras;
Black: 0020 - 0028 and higher 0037
Orange: 0004, 0005, 0009 and 0010
Light blue: ¨above 0004
* MDX-?6300 housings with serial numbers other than the above are only compatible with ?6000 and ?6300 cameras.
.
Improved underwater weight
The weight of the MDX-?6300 is approximately the same as that of the MDX-?6000, but the underwater weight has been improved by redesigning the key components and precision machining.
SA8 accessories can be fitted
.
The MDX-a6300 is compatible with SA8 accessories, making it a compact, high-quality system
.
Two ergonomic thumb rests on the rear walker
.
When the SA8 rail and handles are not in use, the two ergonomic thumb rests can be used to grip the walker securely
.
ML hand strap can be attached
The ML Hand Strap is recommended when no rail or grip is used. With the ML hand strap, you can grip the walker securely with one hand
.
The walker has two accessory ports
.
One port can be used with the optional N-type lightning connector (two pins). The other port can be used with the optional leakage wächter (vacuum system). The 5-pin sync cable/N can be used when a flash (e.g. YS-D2) is connected to the housing, allowing for precise rapid flash triggering.
LCD monitor bonnet with lens can be mounted
.
The bonnet reduces reflections and provides a clear and complete view of the camera's LCD screen
.
Other features
- All camera functions can be used underwater
.
- Equipped with two fibre optic cable jacks.
- Equipped with a lens release button.
- The port lock can be activated from the outside of the housing.
- Powerful luminescent buttons. The controls light up in low-light conditions.
- The camera's built-in flash can be activated and deactivated from the walk-around via the built-in flash off button and flash lock lever.
- Optional leak sensor can be built into the housing. The LED light is located in the LCD monitor window.
- Use of the hand strap is recommended when not using a camera rail . The hand strap helps you to hold the walk use with only one hand.
- Equipped with two sacrificial zinc diodes (one on the front housing and the second on the back) to prevent electrolyte damage.
.
